If you have an above ground pool, you will inevitably have to drain it at some point. Whether it is because you need to do maintenance on the pool or because you are moving and need to take the pool with you, draining an above ground pool is not as difficult as it may seem. With a little bit of planning and the right supplies, you can have your pool drained in no time.
The first step is to figure out where you are going to drain the water. You will need a place that can accommodate all of the water from your pool, so a driveway or other flat surface is ideal. Once you have a spot, you will need to get a hose that is long enough to reach from the pool to the drainage area. You will also need a submersible pump to help move the water.
To begin, you will need to lower the water level in the pool as much as possible. You can do this by using a bucket or a pitcher to remove water from the pool, or by using the hose to siphon out water. Once the water level is low, you can start the pump.
Place the hose in the water and position the pump so that it is above the water level. Turn on the pump and let it run until all of the water has been drained from the pool. Once the pool is empty, you can proceed with whatever maintenance or other activities you needed to do.
Draining an above ground pool is not difficult, but it is important to follow the steps carefully to avoid any accidents. With a little bit of planning, you can have your pool drained in no time, so you can get back to enjoying your summer.
How do you know when the pool is full?
You know the pool is full when the water level reaches the top of the pool. The pool is full when the skimmer basket is full.
How do you know when to stop draining the pool?
There is no one answer to this question as it depends on a variety of factors. Some of the things you will need to consider include the severity of the leak, the size of the pool, and the surrounding environment. You will also need to think about thecost of repairs and the potential for further damage if the pool is not drained properly. Ultimately, you will need to use your best judgment to decide when to stop draining the pool.
What are the consequences of over-draining an above ground pool?
If you over-drain an above ground pool, the consequences can be significant. The pool can become structurally unsound, and the liner can be damaged. Additionally, the pump and filter can be overworked, causing them to break down. Moreover, the pool can become a breeding ground for mosquitoes and other insects.
What are the consequences of under-draining an above ground pool?
pools become stagnant and full of algae. Algae is not only icky to look at, it's also a health hazard. When pools are not properly drained, the water becomes stagnant and unfit for swimming. In addition, the buildup of algae can damage pool equipment and surfaces.
Frequently Asked Questions
How to drain an above ground pool without a pump?
If your pool is above ground, you can use a garden hose to drain the water. Start by turning off the power to the pool and unplugging the pump. Next, connect one end of the hose to a drainage spout on one side of the pool and connect the other end of the hose to a standard drain on ... How to Drain an Above Ground Pool Permanently 1 Remove all objects from around the opening and place a ladder near it. If your pool is built on a concrete slab or has risers, you will need to remove these before draining. 2 Remove …
How much water do you drain from an above ground pool?
Most of the time, you want to drain the pool to be at least 4 to 6 inches below the top of the skimmer.
How do I drain my pool with a hose?
1 Connect one end of the hose to your faucet 2 Put the other end in your swimming pool 3 Turn on the water so it flows into the pool (removes air from the pipe) 4 Detach the end of hose from the faucet and immediately lower it to the ground 5 Watch as the water flow reverses and starts draining the pool
Can pool water be drained into the yard?
Yes, water from above ground pools can be drained into your yard as long as the water is chemically neutral.
How to drain an above ground pool?
Figure out where to dump the water. Before you start emptying the water out of your pool, you'll need to figure out where to dump it. You'll need at least 3 feet of space around the edge of the pool for overflow. Make sure the ground is level and free of rocks before beginning. If your pool has a filter and skimmer, disconnect them before starting. Start a siphon. The easiest way to drain an above-ground pool is to start by connecting one end of a garden hose to the pool's spigot and the other end to a pipe that leads outside. Turn on the water at the hose end, then turn off the main water valve at the house. As the pool fills with water, air pressure pushes it upward through the hose into the pipe and onto your lawn or driveway. Drain the water. Once you have a good flow of water coming out of your hose, turn off the spigot at
